Fusing Film on 1" Cores
Fusing films are used to "Therm-O-Fuse" (post-fuse) toner image areas.
Therm-O-Fusing creates a spot varnish effect on fused toner image areas
and improves toner durability.
THERM-O-TYPE coated and un-coated fusing films are available in 24" wide by 500' or 1,000' rolls on 1" cores.
These rolls are manufactured to work with THERM-O-TYPE foil fusing equipment. All THERM-O-TYPE foil fusing models use standard 1" cores.
ThermoFusing gives a spot varnish look to B&W & color toner images
THERM-O-TYPE coated and un-coated fusing films are available in 24" wide by 500' or 1,000' rolls on 1" cores.
These rolls are manufactured to work with THERM-O-TYPE foil fusing equipment. All THERM-O-TYPE foil fusing models use standard 1" cores.
ThermoFusing gives a spot varnish look to B&W & color toner images
Coated Fusing Film on 1" Cores
1 Roll fusing film
($42.70) ...........................
(24" x 500' rolls)
Coated
3 Rolls fusing film
($126.10) .......................
(24" x 500' rolls)
Coated
5 Rolls fusing film
($213.50) .......................
(24" x 500' rolls)
Coated
Coated Fusing Film on 1" Cores
1 Roll fusing film
($32.00) ...........................
(24" x 500' rolls)
Un-Coated
3 Rolls fusing film
($96.00) .......................
(24" x 500' rolls)
Un-Coated
5 Rolls fusing film
($160.00) .......................
(24" x 500' rolls)
Un-Coated
Fusing Film - Coated
Film is available with or without release agent coating.
Customers who need to Therm-O-Fuse and Foil-Fuse in one pass
should use film with a release agent applied to assure that
toner is not pulled from the sheet by the film during the
higher temperature foil fusing process. Customers who Therm-O-Fuse
in a separate pass can use a lower fusing temperature and do
not require a release coating on the film.
Fusing Film - Un-Coated
Therm-O-Fusing with un-coated fusing film is typically run
at 220 degrees F. Therm-O-Fusing at higher temperatures with
un-coated film may pull toner off the sheet as the toner may
bond to the film.