THERM-O-TYPE Fusing Film

HSFF Film on 1" Cores

Fusing films are used to "Therm-O-Fuse" (post-fuse) toner image areas. Therm-O-Fusing creates a spot varnish effect on fused toner image areas and improves toner durability.

THERM-THERM-O-TYPE coated and un-coated fusing films are available in 24" wide by 500' or 1,000' rolls on 1" cores.

These rolls are manufactured to work with THERM-O-TYPE foil fusing equipment. All THERM-O-TYPE foil fusing models use standard 1" cores.

ThermoFusing gives a spot varnish look to B&W & color toner images

Coated Fusing Film on 1" Cores Film Type

1 Roll fusing film ($42.70)............................(24" x 500' rolls)	Coated
3 Rolls fusing film ($128.10)........................(24" x 500' rolls)	Coated
5 Rolls fusing film ($213.50)........................(24" x 500' rolls)	Coated
Un-Coated Fusing Film on 1" Cores Film Type

1 Roll fusing film ($32.00)............................(24" x 500' rolls)	Coated
3 Rolls fusing film ($96.00)..........................(24" x 500' rolls)	Coated
5 Rolls fusing film ($160.00)........................(24" x 500' rolls)	Coated
Fusing Film - Coated
Film is available with or without release agent coating. Customers who need to Therm-O-Fuse and Foil-Fuse in one pass should use film with a release agent applied to assure that toner is not pulled from the sheet by the film during the higher temperature foil fusing process.
Customers who Therm-O-Fuse in a separate pass can use a lower fusing temperature and do not require a release coating on the film.
Fusing Film - Un-Coated
Therm-O-Fusing with un-coated fusing film is typically run at 220 degrees F. Therm-O-Fusing at higher temperatures with un-coated film may pull toner off the sheet as the toner may bond to the film.

Home I Contact Us I E-Mail I Copyright 2010 I THERM-O-TYPE Corp. I All Rights ReserveD