Hot Foil Stamping Equipment and Presses - THERM-O-TYPE NSF Excel capabilities include flat foil stamping, blind
and foil embossing, die cutting, kiss cutting, perforating, scoring,
imprinting, numbering and HSFF (high speed foil fusing).
Typical NSF Excel applications include greeting cards, business cards,
stationery, invitations and announcements, commercial letterpress work
as well as die cutting and enhancing digital output.
Using the NSF Excel, customers can efficiently produce work at speeds up
to 5,000 sheets per hour.
The NSF Excel can run a 18.5" by 20" maximum sheet size with a 12" by
17.625" impression area.
The NSF Excel is designed around a Windows based computer core with a
full color display and touch screen interface.
Paper registration, foil draw length, counter functions, jam
detect/interrupt, double feed detect, speed and impression pressure
functions are controlled and/or displayed through the computer/touch
Sensors monitor paper movement through the press. If a jam condition
occurs, the machine will automatically drop off impression and stop. Jam
condition information will then appear on the control display.
The headstop paper sensor also confirms each sheet is ready to advance into the
impression area. If a skip feed condition occurs, the NSF Excel will
automatically drop off impression. When the next sheet is detected at
the headstop, the machine will automatically return to the "On"
impression position. The NSF Excel will not stop if a skip sheet error
One feature that has proven popular with operators is the TDC and BDC
(top dead center and bottom dead center) touch screen controls. TDC
represents the most closed position of the imprint mechanism.
BDC represents the most open position of the imprint mechanism. Using
the TDC and BDC controls, operators can quickly and accurately set the
initial impression pressure at the start of each job. This helps to
eliminate the potential for smashing dies due to improper impression
adjustment during set-up.
Customers can batch count on the NSF Excel. To use this feature, the
operator sets a batch quantity and a number of skip feed cycles in the
touch screen control. Once programmed, the NSF Excel will run the
desired batch quantity then skip feed the selected number of cycles to
create a gap between batches on the delivery conveyor.
The standard NSF Excel foil system includes dual foil support shafts,
dual programmable foil draws, and four foil rewind shafts. Multiple foil
draw lengths can be programmed to minimize foil waste. Up to 7.2"
diameter foil rolls can be used and foil draw length can be adjusted
while the machine is running.
The NSF Excel features a computer controlled pneumatic centralized
lubrication system. Lubrication cycles are activated as required using
speed, impression pressure and run/idle time information collected and
processed by the computer.
The NSF Excel incorporates several important mechanical and electrical
safety features. A dedicated 24-volt safety circuit with emergency stops
switches; fail-to-safe relay and reset button have been installed. All
controls and switches mounted to the control panel operate at 24-volts
The NSF Excel feeder can hold a 32" high pile of stock. This feeder can
be pre-loaded while the press is running to minimized down time. The
combination of high capacity feeder and pre-loading significantly
increases productivity, while reducing operator workload.
The NSF Excel is the culmination of over 25 years of collaborative work
between major producers of foil stamped, embossed and die-cut products
and THERM-O-TYPE Corporation.
Exceptional fast set up, high productivity, accuracy and high quality
output make the NSF Excel Foil Stamping Presses are the most profitable machine purchases
you can make for your business.
For more information on Hot Foil Stamping Equipment call
1-800-236-9630. Outside the United State call 1-941-488-0123.
I Copyright 2017
I All Rights Reserved I Made in the
U.S.A I Quality, Service & Innovation